Must have minimum of three windshield bars in front of driver. May have two bars for protection in front of radiator, behind bumper within confines of body, no wider than stock frame horns. Tubing may be added from top of roll cage to rear frame section to protect fuel cell. May have front hoop from roll cage forward to protect radiator. Must have minimum of one cross bar in the top of halo of roll cage. On uni-body cars, cage will be mounted to four 1/4″ plates and mounted to the floor with four 1/2″ bolts per plate. Top halo must be no less than 40″ across, inside to inside. Location: No more than 41″ from top center of windshield to front edge of rear hoop. Must be electric welded and well constructed. Other materials are subject to prior approval. Low carbon, mild steel tubing is recommended. seamless tubing and must have a wall thickness of. Material must not be less than 1.625″ O.D. Rub rails no bigger than 1″ by 2″ may be attached to the body from fender well to fender well and rear quarter panel, flush with body and painted to match car.Īll cars must have minimum 4 point roll cage. Minimum 108″ wheelbase, maximum 1” difference from side to side.
#DIRT TRACK STOCK CAR RACING FULL#
manufactured full body rear wheel drive passenger car with full frame or uni-body. Leaving tech area without Tech or other Track Officials approval will result in a disqualification.Īny U.S.
#DIRT TRACK STOCK CAR RACING DRIVER#
Must have an additional master shut off switch mounted BEHIND driver seat on horizontal surface (floor is not acceptable), clearly marked “on/off”, and be easily accessible from outside of car. Kill switch to be mounted within easy reach of driver and clearly marked “on/off”. 25″ by 2″ steel mounted 6″ from the front of the driveshaft. 360 degree driveshaft loop required and must be constructed of at least. Aluminum racing seats only and must be securely fastened to roll cage. Five point safety harness is required and must be securely mounted to roll cage using 1/2″ diameter bolts. Window net to be mounted so latch is at the top front of window. 16X20 driver side ribbon or mesh type window net or arm restraints required. SFI approved full fire suits, fire retardant neck braces and gloves are required. Helmets must be worn at all times including packing.
![dirt track stock car racing dirt track stock car racing](https://i.etsystatic.com/17060651/r/il/04dedb/2423009754/il_794xN.2423009754_g3bz.jpg)
![dirt track stock car racing dirt track stock car racing](https://dailygazette.com/wp-content/uploads/2020/06/Recorder-Fonda-Pic-1-608_0-scaled.jpg)
Required helmets must be Snell SA2000, SFI 31.1/2005 or newer.